HYDRAULIC TECHNOLOGY INC. 

    Home Up Request for Info Search Request For Quote   

Customize your own Hydrostatic Test System

Start with the basic Model 9901 hydrostatic tester as shown with the following standard equipment:9901 Hydrostatic tester for hydrostatic tesing

bulletHydrostatic test pump.
bulletMicro adjust precision regulator.
bullet¾" swivel female hose inlet with strainer.
bulletANSI B40.1 Grade B air pressure gauge.
bulletAutomatic lubricator.
bulletAir shutoff valve.
bulletStainless steel high pressure manifold.
bullet1/4" NPT accessory port.
bulletBleed valve.
bulletFactory set air pressure relief valve.
bullet7/16-20 straight thread o-ring boss outlet port
(MS33649-04) with -4 male adapter fitting .
bullet1% ANSI B40.1 Grade 1A stainless steel high
pressure gauge with peak read feature.
bulletStainless steel base plate with rubber feet.

Then customize your hydrostatic test equipment by selecting the options below that most suit your needs:

Testers can be ordered with the high pressure manifold that includes a return loop connection in order to bleed out the system.  This configuration is typically used for testing hose assemblies.  Where the air bleed is accomplished at the item under test, a non loop manifold is usually desired.  This is the most common configuration and is pictured above.  Please specify the type required. 
 
Unless otherwise specified, crack pressure will be factory set at maximum of pressure range selected. Additional springs available to cover complete range of tester.    If required, please specify below.  Please note relief valves not available for pressures above 10,000 psi.

Analog gauges are more accurate in the middle half of scale.  Digital gauges are more accurate at the lower and upper end of scale.  If burst testing is anticipated, testing is to be performed at both the lower and upper ends of scale or if higher accuracies are required, a digital gauge is recommended.  If testing is to be performed in the upper two thirds of scale, and 1% full scale accuracy is acceptable, then the analog gauge is should suffice.  Both digital gauges come standard with peak read feature and selectable units of measure (psi, inHg, cmHg, mmHg, kPa, mPa, Bar, kg/cm2, ftH2O).

Standard high pressure manifold combines bleed valve, high pressure gauge port, high pressure output port and relief valve/accessory port into one manifold.  High pressure stainless isolation valve is standard on all units. For chamber units only, in addition to the main manifold, optional multi-port manifolds can also be ordered mounted to the chamber.  If a multi-port manifold is are required, please specify total number of pressure ports required for the manifold . Does not apply to loop systems.


Test chambers are available to protect personnel during proof or burst testing.  Chambers are manufactured in lab quality polished stainless steel with a clear Lexan door for visibility during testing.  Port(s) are provided inside the enclosure, while all controls remain outside the enclosure for operator safety.  Please select from standard units or specify a different size or configuration based on your particular requirements.
Other 


Various stainless steel test adapter fittings are available for connecting to different size and configuration hose assemblies. 
Please choose from stocked adapter fittings
or specify alternate requirements. Other 


Test Hose Assemblies:
3 ft (1 ea)    3 ft (2 ea)    6 ft (1 ea)    6 ft (2 ea)    12 ft (1 ea)    12 ft (2 ea)  
Other 

Please list any items, features or other unique requirements not listed above that you require:
 

Please provide the following contact information:

Organization
Name
Tel.
Fax
E-mail

 
 
Copyright (c) 1995-2012 - Hydraulic Technology Inc. - All rights reserved