Test System, Hydrostatic, 0-6000 psi
P/N 9501, 9501A, NSN 4320-00-420-3206; 9501B, NSN
4320-01-518-3888
 Used by
the U.S. Air Force for their hydrostatic testing requirements, the 9501 hydrostatic test
system provides a safe source of hydraulic pressure for proof testing pressure vessels or
other components that require periodic proof pressure testing. The unit is air
operated and will supply output pressures from 0 to 6000 psi from an air supply of 0 to
100 psi. The unit is designed for use with potable water which is connected via a
standard 3/4" hose connection. Ambient hose pressure quickly fills the unit to
be tested, after which the test pump is operated until test pressures are achieved.
The unit can also be used with P-D-680 solvent, MIL-H-5606 hydraulic fluid or other
petroleum based fluids. With fluids other than water, a is supplied with two separate relief valves to protect from
over-pressurization, one located at the air inlet to the pump and the other located on the
high pressure side of the system. When ordered with the optional digital pressure gauge
(standard on 9501B models), burst test
readings are easily accomplished using the peak read memory feature of the gauge. A
removable cover is available which serves to protect the unit when not in service.
Depending on user requirements, the Test System can be ordered with different
maximum output pressures ranging from 2000 psi up to 15,000 psi. To configure a unit to meet your specific
requirements, please
proceed to the Customization
Page.
Specifications:
 | Portable or Bench Mount
|
| Approximate Dry Weight – 36 pounds
|
| Dimensions – 16" Long X 14" Wide X 13" High.
|
| Discharge Pressure Ranges Available – 0-2000, 0-6300,
0-10,000, 0-15,000 psi
|
| Inlet Air Requirements – 8 cfm at 100 psi.
|
| Fluid – Water, P-D-680 solvent, MIL-H-5606 hydraulic
fluid and most other petroleum based fluids.
|
| Factory set air pressure relief valve – Prevents
over-pressurization of tester.
|
| Adjustable high pressure fluid relief valve – Prevents
over-pressurization of unit under test.
|
| High Pressure Gauge – 1/2% accuracy digital gauge with peak read memory
feature, selectable units of measure.
|
| Output isolation valve – Used to isolate unit under test.
|
| Bleed Valve – Releases pressure prior to disconnecting unit
under test.
|
| All stainless steel wetted components – Strength,
durability, corrosion resistance.
|
Back to Hydrostatic Testers
|
