Our modular hydrostatic test chambers are designed with open ends to accommodate the connection to similar units for the purpose of lengthening the enclosed test area. The modular test system starts with a base unit with complete pump system, gauges and controls mounted on the 60” x 24” x 18” test chamber. If longer test lengths are required, simply add another test chamber to double, triple or quadruple the test length area. With this design, you can add a pump system later so that an extension chamber could be utilized independently as a stand-a-lone system, while still being able to connect to other chambers when the extra length was required. Pass through area between connected test chambers measures approximately 19.5” x 13”.

• Test Chamber: 12 gauge brushed stainless, nominal 60" x 24" x 18" deep chamber, venting to rear of chamber
• Polycarbonate door: 1/2" thick x 42” wide x 24” deep
• Stainless "double lock" heavy duty latches handle and gas springs
• Four each polyurethane locking swivel castors
• Max pressure ranges: 1000, 2300, 3600, 6300, 10,000 and 15,000 psi
• Four inch dial gauge, 1% accuracy (optional - 1/4% digital gauge)
• Output Shutoff Valve: Used to isolate test item and gauge from test system
• Stainless manifold with bleed valve and accessory port
• Inlet Air Requirements: max 8 cfm at 100 psi
• Fluid: Water, MIL-H-5606, MIL-H-83282 or other petroleum based fluids (Other fluids upon request).
• Variety of optional hose adapters available mounted in laser cut storage inserts.
• 1/2" NPT drain
• Overall Dimensions on castors: 60" x 24" x 49" High
• Chamber Weight: 295 lbs (147 kg)
• Pump System Weight: 39 lbs